|
In music, there are two common meanings for tuning: * Tuning practice, the act of tuning an instrument or voice. * Tuning systems, the various systems of pitches used to tune an instrument, and their theoretical bases. ==Tuning practice== Tuning is the process of adjusting the pitch of one or many tones from musical instruments to establish typical intervals between these tones. Tuning is usually based on a fixed reference, such as A = 440 Hz. ''Out of tune'' refers to a pitch/tone that is either too high (sharp) or too low (flat) in relation to a given reference pitch. While an instrument might be in tune relative to its own range of notes, it may not be considered 'in tune' if it does not match A = 440 Hz (or whatever reference pitch one might be using). Some instruments become 'out of tune' with damage or time and must be readjusted or repaired. Different methods of sound production require different methods of adjustment: * Tuning to a pitch with one's voice is called ''matching pitch'' and is the most basic skill learned in ear training. * Turning pegs to increase or decrease the tension on strings so as to control the pitch. Instruments such as the harp, piano, and harpsichord require a wrench to turn the tuning pegs, while others such as the violin can be tuned manually. * Modifying the length or width of the tube of a wind instrument, brass instrument, pipe, bell, or similar instrument to adjust the pitch. The sounds of some instruments are ''inharmonic''—they have irregular overtones not conforming to the harmonic series. Tuning may be done aurally by sounding two pitches and adjusting one of them to match or relate to the other. A tuning fork or electronic tuning device may be used as a reference pitch, though in ensemble rehearsals often a piano is used (as its pitch cannot be adjusted for each rehearsal). Symphony orchestras and concert bands tend to tune to an A or a B♭, respectively, provided by the principal oboist or clarinetist. Interference beats are used to objectively measure the accuracy of tuning. As the two pitches approach a harmonic relationship, the frequency of beating decreases. When tuning a unison or octave it is desired to reduce the beating frequency until it cannot be detected. For other intervals, this is dependent on the tuning system being used. Harmonics may be used to facilitate tuning of strings that are not themselves tuned to the unison. For example, lightly touching the highest string of a cello at the middle (at a node) while bowing produces the same pitch as doing the same a third of the way down its second-highest string. The resulting unison is more easily and quickly judged than the quality of the perfect fifth between the fundamentals of the two strings. ===Open strings=== (詳細はmusic, the term open string refers to the fundamental note of the unstopped, full string. The strings of a guitar are normally tuned to fourths (excepting the G and B strings in standard tuning, which are tuned to a third), as are the strings of the bass guitar and double bass. Violin, viola, and cello strings are tuned to fifths. However, non-standard tunings (called scordatura) exist to change the sound of the instrument or create other playing options. To tune an instrument, often only one reference pitch is given. This reference is used to tune one string, to which the other strings are tuned in the desired intervals. On a guitar, often the lowest string is tuned to an E. From this, each successive string can be tuned by fingering the fifth fret of an already tuned string and comparing it with the next higher string played open. This works with the exception of the G string, which must be stopped at the fourth fret to sound B against the open B string above. Alternatively, each string can be tuned to its own reference tone. Note that while the guitar and other modern stringed instruments with fixed frets are tuned in equal temperament, string instruments without frets, such as those of the violin family, are not. The violin, viola, and cello are tuned to beatless just perfect fifths and ensembles such as string quartets and orchestras tend to play in fifths based Pythagorean tuning or to compensate and play in equal temperament, such as when playing with other instruments such as the piano. For example, the cello, which is tuned down from A220, has three more strings (four total) and the just perfect fifth is about two cents off from the equal tempered perfect fifth, making its lowest string, C-, about six cents more flat than the equal tempered C. This table lists open strings on some common string instruments and their standard tunings. 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「In music, there are two common meanings for tuning:* Tuning practice, the act of tuning an instrument or voice.* Tuning systems, the various systems of pitches used to tune an instrument, and their theoretical bases.==Tuning practice==Tuning is the process of adjusting the pitch of one or many tones from musical instruments to establish typical intervals between these tones. Tuning is usually based on a fixed reference, such as A = 440 Hz. ''Out of tune'' refers to a pitch/tone that is either too high (sharp) or too low (flat) in relation to a given reference pitch. While an instrument might be in tune relative to its own range of notes, it may not be considered 'in tune' if it does not match A = 440 Hz (or whatever reference pitch one might be using). Some instruments become 'out of tune' with damage or time and must be readjusted or repaired.Different methods of sound production require different methods of adjustment:* Tuning to a pitch with one's voice is called ''matching pitch'' and is the most basic skill learned in ear training.* Turning pegs to increase or decrease the tension on strings so as to control the pitch. Instruments such as the harp, piano, and harpsichord require a wrench to turn the tuning pegs, while others such as the violin can be tuned manually.* Modifying the length or width of the tube of a wind instrument, brass instrument, pipe, bell, or similar instrument to adjust the pitch.The sounds of some instruments are ''inharmonic''—they have irregular overtones not conforming to the harmonic series.Tuning may be done aurally by sounding two pitches and adjusting one of them to match or relate to the other. A tuning fork or electronic tuning device may be used as a reference pitch, though in ensemble rehearsals often a piano is used (as its pitch cannot be adjusted for each rehearsal). Symphony orchestras and concert bands tend to tune to an A or a B♭, respectively, provided by the principal oboist or clarinetist.Interference beats are used to objectively measure the accuracy of tuning. As the two pitches approach a harmonic relationship, the frequency of beating decreases. When tuning a unison or octave it is desired to reduce the beating frequency until it cannot be detected. For other intervals, this is dependent on the tuning system being used.Harmonics may be used to facilitate tuning of strings that are not themselves tuned to the unison. For example, lightly touching the highest string of a cello at the middle (at a node) while bowing produces the same pitch as doing the same a third of the way down its second-highest string. The resulting unison is more easily and quickly judged than the quality of the perfect fifth between the fundamentals of the two strings.===Open strings===Open string (music) redirects directly here.-->(詳細はStringed instrument tuningsを参照)In music, the term open string refers to the fundamental note of the unstopped, full string.The strings of a guitar are normally tuned to fourths (excepting the G and B strings in standard tuning, which are tuned to a third), as are the strings of the bass guitar and double bass. Violin, viola, and cello strings are tuned to fifths. However, non-standard tunings (called scordatura) exist to change the sound of the instrument or create other playing options.To tune an instrument, often only one reference pitch is given. This reference is used to tune one string, to which the other strings are tuned in the desired intervals. On a guitar, often the lowest string is tuned to an E. From this, each successive string can be tuned by fingering the fifth fret of an already tuned string and comparing it with the next higher string played open. This works with the exception of the G string, which must be stopped at the fourth fret to sound B against the open B string above. Alternatively, each string can be tuned to its own reference tone.Note that while the guitar and other modern stringed instruments with fixed frets are tuned in equal temperament, string instruments without frets, such as those of the violin family, are not. The violin, viola, and cello are tuned to beatless just perfect fifths and ensembles such as string quartets and orchestras tend to play in fifths based Pythagorean tuning or to compensate and play in equal temperament, such as when playing with other instruments such as the piano. For example, the cello, which is tuned down from A220, has three more strings (four total) and the just perfect fifth is about two cents off from the equal tempered perfect fifth, making its lowest string, C-, about six cents more flat than the equal tempered C.This table lists open strings on some common string instruments and their standard tunings.」の詳細全文を読む スポンサード リンク
|